Hi EveryOne
I Have 3 Types of Alexa . Alexa echo dot 5th and 4th and show 15
when i say to it to set timer for example 20 hours (in my region in IRAN) , its OK.but i wanna say it to set timer based on Time Zone in another Country For Example  Canada Vancouver . How Can i Command That?
Set alarm for 8 a.m in Canada Vancouver? (not true)

I have an Echo 8 and a Wyze Video Doorbell V2 - both at current firmware levels. My iPhone and Echo both react to doorbell rings and get notifications. However, while the iPhone gets motion alerts, the Echo does not show any motion notifications. Why not? Is there some special action that I need to do to link the Wyze motion alerts to my Amazon/Echo account? I can't imagine any technical/programming reason that any notification that the iPhone Wyze app gets can't be passed on to the Echo - either directly or indirectly. I do no want to use a facility such as IFTTT.

After several months now without a single failure of any zigbee device linked through a separate hub to my echo plus I am now ready to call all the drop failures of direct connected devices to the echo build-in hub caused by the amazon side and hence gives me a degree of satisfaction to have found the route cause of my previous failures to keep my devices consistently operable.

what hub did you get?    I do not use the hub on the echo devices either.   I just make sure whatever smart device I get, it will work with wifi,ring or hue hubs.   

Thanks for responding.....yes, I usually wait about a minute with it unplugged.  I don't normally recycle the router....but tried that after your reply....still happened.

And yes...I checked the firmware.....

It's just odd because it doesn't happen every time.....it's usually once a day for sure, sometimes twice...and once it does it, and the light goes back out, then everything is fine....

I might just end up moving that one to a different location and bringing one of the gen 4 dots back into the bedroom.

moving to a different location could help.   Maybe for a test, move it to the same room as the router to make sure there is not a signal issue or swap it with another device that is not having problems

Thanks for responding.....yes, I usually wait about a minute with it unplugged.  I don't normally recycle the router....but tried that after your reply....still happened.

And yes...I checked the firmware.....

It's just odd because it doesn't happen every time.....it's usually once a day for sure, sometimes twice...and once it does it, and the light goes back out, then everything is fine....

I might just end up moving that one to a different location and bringing one of the gen 4 dots back into the bedroom.